Facebook X / Twitter Instagram LinkedIn
1-844-264-8994
Home › Resources › 300 / 500 / 700 Series › Correct Loose LMI Cord

Correct Loose LMI Cord

Correct a loose load-moment-indicator cord. This video is part of the 300 / 500 / 700 Series resources library. Click play to load the YouTube player. Resources are an operator aid and do not replace the operator's manual or the load chart on the crane.

300 / 500 / 700 Series · Operator how-to video

Video transcript

Transcript for this video. Not a substitute for the operator's manual.

[Music]

Correcting a Loose LMI Cord

Applicable to all LMI-equipped 300, 500, and 700 Series SPYDERCRANE®.

A loose LMI cord will be slack between the LMI cord reel and the boom tip. This typically occurs when a length of cord falls off the reel.

To perform this procedure, leave the SPYDERCRANE off and in travel mode.

The LMI cord reel is supported by two brackets that leave the back of the reel exposed and accessible. Rotating the LMI cord reel counterclockwise, unreel enough LMI cord to form a large loop.

[Music]

Feed the loop in between the two LMI cord reel brackets and loop it over the rear of the cord reel. Release the LMI cord and allow the cord reel to tighten up the cord.

[Music]

Back to 300 / 500 / 700 Series All Resources Operator Training

SPYDERCRANE® Resources are provided as an operator aid. Information can change and is not a substitute for proper training, the operator’s manual, or the load chart on the crane.